LEW Series Vertical Wall Mount Aluminum Tube-Electric Heat Air Handlers
Features and Benefits
• Rifled copper tubing, enhanced aluminum fins
• Immersion-tested at 500 psi, then nitrogen-pressurized and sealed
• Left- or right-hand refrigerant and plumbing connections
• Liquid line – 3/8” ODS, suction line – 3/4” ODS on 1-1/2- 3 ton & 7/8” ODS on 3-1/2 – 5 ton
• 10-Year Limited Warranty VIEW WARRANTY CERTIFICATE
APPLICATION VERSATILITY
Front or bottom return air position.Offset hanging brackets attach to unit and wall to allow hanging inside closet. Can be AHRI matched with most brands of air conditioners or heat pumps. ETL listed for use with either R-22 or R-410A when a proper metering device is used.
MOTOR
Constant torque ECM speeds and torques are controlled by software embedded in the motor to maintain constant torque. Motors are pre-programmed at the factory.
LOW LEAKAGE CABINET
Less than 2% air leakage from cabinet when tested in accordance with ASHRAE standard 193. Unit must be installed according to Aspen installation instructions. Sturdy, fully insulated galvanized steel cabinet; stick pins ensure ½” insulation remains in place. Unit ships with disposable filter.
BLOWER
Direct drive multi-speed blowers circulate air quietly and efficiently. Motor speeds can be easily selected via motor terminals. Swing mounted blowers can be easily removed for service.
MODULAR ELECTRIC HEAT KITS
Heat kits available with either circuit breakers or terminal blocks. Available in 3,5,6,8, and 10 KW. Models with electric heat include sequencers and temperature limit switches for safe, efficient operation. Modules are easily installed in the field using molex plugs or can be ordered factory-installed. Controls are accessible from the front for easy service and electrical connections can be made from the top or left.
Disconnect does not protrude through the wall panel. Fan time delay relay standard for increased efficiency.
ELECTRONIC CONTROL BOARD
Electronic circuit board provides 30 secs ON/OFF blower time delay extracting more heat/cool from the coil. Automotive-style pull fuse protection on the circuit board to provide low voltage and transformer protection.
DX COIL
High efficiency rifled aluminum tubes/enhanced aluminum fins provide maximum heat transfer. All coils factory leak tested with two-stage pressure decay and mass spectrometer process then nitrogen pressurized and factory sealed for maximum reliability. Liquid-line Schrader allows pre-installation pressure testing. Available with either check style flowrater or TXV metering device. Field-installable TXVs are also available. Galvanized metal drain pan with bottom primary and secondary ¾” FPT drain connections, or alternate right side primary. Access door allows for coil cleaning.
OPTIONS
See Options menu.
